DISPLAY MENUS

As usual once you power up the SPARKX i7 AI for the first time it will ask you to choose language, remove the transport brackets and any obstructions, connect it to the internet (Wi-Fi) and allow it to run a self-check.

After these steps are completed, the printer will check for available firmware updates and if any it will notify you.

The main tab is mostly the same as with past models so from here you can choose to start printing any of the models stored on its memory or on the USB drive, adjust temperature of the heat bed and hotend, adjust printing speed, enable night mode (less noise, increases print time), turn on/off the 2 LEDs of the 720p AI camera and adjust cooling fan speed.

You can also access the filament and X/Y/Z control tabs.

Inside the print settings tab you'll find settings for the RGB light strip, sound effects, nano CFS, feedback, nozzle, AI detection and expert mode.

Moving to the system settings tab here you can access the WLAN, my device (information), firmware (updates), screen brightness, screen off timer, language, root account and can also perform a factory reset.

Typically, inside the maintenance tab you'll find the calibration tab along with tabs for routine maintenance and replacement of consumables.