THE COOLFORCE 1 INTERIOR

Here we see the noise-dampening material placed on the interior of the left side panel (same applies for the right one).

As you can all see from the above picture interior space is very good for a mid-tower (Nanoxia has placed 7 rubber grommets on the mainboard tray for cable management).

Both 5.25" drive bays feature easy-lock mechanisms and there are even two rubber grommets on the bottom of the base one if you decide to use a 240mm radiator at the front (mounting a 280mm radiator would require to remove the 5.25" bays).

Nanoxia has placed three easy-mount HDD sleds for both 2.5/3.5" drives.

To remove them you will need to access the other side of the tower and release their thumbscrews.

These sturdy sleds are made out of aluminum and feature a piece of rubber at the rear to avoid the transferring of vibrations to the case.

At the rear of the mainboard tray Nanoxia has placed a vertical 2.5" drive tray made by aluminum (not as impressive as the sleds but it gets the job done).

All 7 PCI expansion slots are kept in place with regular thumbscrews.

Moving at the bottom of the CoolForce 1 we see four small rubber feet on the PSU area, the HDD mounting rails (can be removed to place a 120mm fan there) and another 2.5" HDD tray.