THE CRONOS 710S EXTERIOR

The Cylon Pro is a medium sized mid-tower that measures 480mm in height, 400mm in depth and 205mm in width.

As already mentioned, the entire right side panel is made out of tempered glass held in place via 4 thumbscrews.

The fascia is made entirely out of ABS plastic and has a RGB LED strip at the bottom.

You can remove the fascia by pulling it from its base to access the interior fan/radiator area.

Here you can mount up to three 120/140mm fans or a 240/280/360mm radiator (from the above picture the front seems to have been designed to accommodate two 5.25" drives instead of a 3rd fan).

The I/O is located at the top of the fascia and includes the reset button, power and HDD activity LEDs, two USB 2.0 ports, headphones and microphone 3.5mm ports, two USB 3.0 ports and the on/off power button (located at the front of the fascia just beneath the I/O).

Most of the top area is covered by a magnetic air-filter beneath which you can install again either two 120/140mm fans or a single 240/280mm radiator.

Moving at the rear of the case we find the 120mm auto ring spectrum RGB exhaust fan, 7 PCI expansion slots with a removable cover and the PSU area.

At the base of the CRONOS 710S we find a removable air-filter right under the PSU area (not a magnetic one).