THE H100I PRO RGB

As expected after testing both of its predecessors the H100i Pro RGB is a high quality radiator/tubes/pump/waterblock combo.

According to our tool the radiator is exactly 26.5mm thick (very close to the 27mm reported by CORSAIR - and since calibrations issues do exist with tools ours could be a bit off).

Just like the radiator used in the H115i/H150i Pro RGB models this one also has an FPI (fins per inch) count of 21.

Once again the radiator is connected to the pump/waterblock combo via two 350mm long black sleeved low permeability tubes.

The CORSAIR logo is as usual located ontop of the pump/waterblock combo (an RGB LED is placed right beneath it).

A micro USB port which needs to be connected to your mainboard USB header (for the LINK and iCUE software suites to work) is located at the front of the base.

The tubes used with the H100i Pro RGB can rotate up to roughly 100 degrees from the base (exactly like the ones used in the H115i/H150i Pro RGB).

The all copper base (coldplate) comes ready with a pre-applied layer of thermal conductive material on it.

In terms of connectors the H100i Pro RGB has two four-pin (PWM) fan connectors, one SATA power connector and a three-pin fan connector for the pump.

Just like with the H115i/H150i Pro RGB the H100i Pro RGB is bundled with fans from the "regular" (non RGB) ML line by CORSAIR.

With both 120mm fans installed the thickness of the H100i Pro RGB climbs to around 52.11mm.