THE AIR PRO 2

By shipping the new Air Pro 2 model with a total of 6 silicon eartips (1 already pre-mounted) EarFun makes certain that they'll fit well in your ear.

Unlike the Air Pro the Air Pro 2 follow the same basic design introduced by the Apple AirPods Pro (something which many other manufacturers have done so since, the why however is beyond me).

EarFun has placed their logo on the front exterior of both earbuds.

Each earbud has external touch controls so you can use a double tap on either one to pause/resume playback and answer/end calls (hold for 2s to reject a call), tap 3 times on the right for next track and 3 times on the left for previous track, tap once on the right to increase volume and on the left to decrease volume and tap and hold for 2 seconds on the right to enable voice assistant mode and on the left to enable/disable ANC.

At the front of each earbud, we see the voice pickup microphone which is placed near the left/right markings and the two charging contacts.

Further at the rear we find an infra-red sensor (ear on/off sensor) and one of the two feedback microphones.

The second feedback microphone is located at the base of the earbuds as seen above.

Using 10mm large drivers is not something we haven't seen before (still they should produce good bass levels).

The charging case has the company logo on top and a USB type-C charging port at the rear.

Opening the case reveals a single resting area for the earbuds and a button at the center.

 You can actually reset the earbuds to their factory state by pressing this button for 8 seconds.

Also, i forgot to mention that a battery charging LED is located at the front of the case.