28 - 03 - 2024
Login Form



 


Share this post

Submit to FacebookSubmit to TwitterSubmit to LinkedIn

 

 

THE AIRCAM OD-2025HD 

 

 

 

 

 

 

 

 

airlive od 2025hd 007t

The IP-66 wheatherproof certified housing measures 97mm in length, 86mm in width and 81mm in height.

 

 

airlive od 2025hd 008t

The 2MP (Megapixel) CMOS sensor can record Full HD (1080p) video at 30fps while the wide angle 4.0mm lens can monitor anything inside an horizontal angle of up to 87 degrees. You can remove the front cover and manually setup the lens (focus) for the best possible result if by default the unit is out of focus. Also the 24 surrounding IR LEDs can illuminate a distance of up to 25 meters.

 

 

airlive od 2025hd 009t

The Airlive logo is placed on both sides of the top cover.

 

 

airlive od 2025hd 010tairlive od 2025hd 011t
The top cover/shield is large enough to cover the entire camera however you will need to slide it towards the front to provide the best possible protection for the lens.

 

 

airlive od 2025hd 012t

There are two positions (holes) you can use for the top cover, according to the angle you use the camera at.

 

 

airlive od 2025hd 013tairlive od 2025hd 014t
Here you can see the top cover all the way retracted and extended.

 

 

airlive od 2025hd 015tairlive od 2025hd 016t
Personally i think that the first position is also the best if you use the camera at an angle (facing down).

 

 

airlive od 2025hd 017t

At the rear end the OD-2025HD comes with everything you'd ever need including a DIDO alarm connector, BNC connector, AC power plug, Microphone mini-jack, reset button, Audio out mini-jack and the RJ45 Ethernet port.

 

 

airlive od 2025hd 018t

Turning the device over we see a large sticker with the default IP address, user name and password of the unit.

 

 

airlive od 2025hd 019t

The holes at the bottom of the camera are used to mount the wall base.

 

 

airlive od 2025hd 020t

As you can see the wall base is not very thick (would prefer it that way) but it gets the job done.

 

 

airlive od 2025hd 021t

To mount the camera you will need to remove the small upper/front part of the base, attach it onto the camera and then attach it with the camera onto the rest of the base. You can also adjust the vertical angle from the small upper part (lower screw).

 

 

airlive od 2025hd 022t

The screws found at the bottom of the wall base allow you to adjust the horizontal position of the camera.