THE WATER 3.0 PRO

Just like all AIO Liquid Cooling Solutions the Water 3.0 Pro consists from the Radiator (49mm thick), two rubber tubes and a CPU waterblock with an built-in pump.

The state of the radiator fins is not the best we've ever seen but not the worst either.

Both rubber tubes are 326mm long so you shouldn't have any issues installing the Water 3.0 Pro even at the furthest places in your tower.

Although the size of the pump is virtually the same as the one used in the Water 2.0 models still it's not only faster (2800RPM vs 2900RPM) but it's also less power hungry (0.5A vs 0.3A).

The waterblock is made out of copper and comes with a pre-applied layer of thermal conductive material.

Both tubes can swivel up to 90 degrees to further simplify the installation of the cooler.

The 120mm fans Thermaltake bundles with the Water 3.0 Pro can achieve speeds up to 2000RPM to produce up to 99CFM of airflow with just 20dBA of noise.

With both fans mounted on the radiator it now measures almost 100mm in width.