KUHLER H2O 1250

The KUHLER H2O 1250 is basically an 240mm radiator with two 120mm fans, two integrated pumps, two rubber tubes and a waterblock.

Just like with the 650 and 950 models the two high-RPM 120mm fans attached on the 1250 are fixed and can't be replaced (both fans can spin up to 2400RPM).

An integrated high performance pump is placed on top of each of the two fan motors.

The radiator is 280mm long, 120mm wide and just 27mm thick (would had been much better if it was 50mm thick like the one of the 950 model).

As you can see the fins are in perfect condition which is more than i can say for a few other similar solutions.

The rubber tubes are 300mm long and very flexible.

Once again the thin waterblock has the company name on top of a LED that changes color according to the temperature of the liquid.

Both tubes can swivel up to 90 degrees to make installation easier.

The copper base comes ready with a thin pre-applied layer of thermal conductive material.

To use the KUHLER H2O 1250 you need to plug it into a USB 2.0 header in order to control it via the GRID software and a 3pin fan header to give it power. There are also two extra 4pin power fan headers in case you decide to use two more 120mm fans in push and pull.